R310

The R310 is an entry level two-stream, dual-band, 802.11ac Access Point with adaptive antenna technology for carriers and enterprises.
Note: The minimum software revision for the R310 is standalone AP base image 102.0 or later, SmartZone 3.2 or later, or ZoneDirector 9.12.2 or later.
Note: The R310 does not support Smart Mesh or Spectrum Analysis, and supports a maximum of 100 unencrypted clients.

Front View Features

The R310 includes five LEDs on its front panel and buttons and connectors on its rear panel.

R310 front view

R310 front panel elements

LED Description
PWR LED
  • Off: Off.
  • Red: Boot up in process.
  • Flashing Green: No routable IP address
  • Green: On.
AIR LED
  • Not used in this model.
CTL LED
  • Off: The AP is not being managed by a controller (standalone mode).
  • Green: The AP is being managed by a controller.
  • Slow flashing green (one flash every two seconds): The AP is being managed by a controller, but is currently unable to communicate with the controller.
  • Fast flashing green (two flashes every second): The AP is being managed by a controller and is currently receiving configuration settings (provisioning) or an image update.
2.4G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated.
5G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated.

Rear Panel Features

The rear panel of the R310 includes one 10/100/1000 PoE Ethernet port, power socket and reset button. See the table below for a description of each rear panel part.

R310 rear panel

R310 rear panel elements

Item Name Description
10/100/1000+PoE Port One RJ-45 port for a 10/100/1000 PoE (Power over Ethernet, 802.3af) connection.
RST Button Pressing, and then quickly releasing this internal button reboots the AP. Pressing and holding it for six seconds resets the AP to factory default settings.
Note: Resetting the AP to factory default settings erases all previously configured settings.
Power Connect the power adapter (12 VDC/1.25A) to this socket. Power can also be supplied via the 10/100/1000 PoE port.