R750

The R750 is a 4x4:4 11ax (5GHz) + 4x4:4 11ax (2.4GHz) dual-band concurrent indoor AP.
Note: The minimum software revision for the R750 is SmartZone 5.1.1 or later, ZoneDirector 10.3 or later.

Front View Features

The R750 includes five LEDs on its front panel and buttons and connectors on its rear panel.

R750 front view

R750 front panel elements

LED Description
PWR LED
  • Off: Off.
  • Red: Boot up in process.
  • Flashing Green: No routable IP address
  • Green: On.
CTL LED
  • Off: The AP is not being managed by a controller (standalone mode).
  • Green: The AP is being managed by a controller.
  • Slow flashing green (one flash every two seconds): The AP is being managed by a controller, but is currently unable to communicate with the controller.
  • Fast flashing green (two flashes every second): The AP is being managed by a controller and is currently receiving configuration settings (provisioning) or an image update.
AIR LED
  • Off: The AP is operating in standalone mode or operating as a root AP (RAP) or a non-mesh AP
  • Green: The AP is functioning as a Mesh AP (MAP), and the wireless signal to its uplink AP is good.
  • Slow flashing green (one flash every two seconds): Mesh networking is enabled, but the AP is still searching for a mesh uplink.
  • Fast flashing green (two flashes every second): The AP is functioning as a Mesh AP (MAP), and the wireless signal to its uplink AP is fair.
2.4G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated.
5G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated.

Rear Panel Features

The rear panel of the R750 includes one 100/1000/2500 PoE Ethernet port, power socket and reset button. See the table below for a description of each rear panel part.

R750 rear panel

R750 bottom panel elements

Item Name Description
100/1000/2500 + PoE Port One RJ-45 port for a 100/1000/2500 PoE (Power over Ethernet, 802.3af/at) connection.
10/100/1000 + non-PoE Port One RJ-45 port for a 10/100/1000 PoE connection.
48V 0.75A 48V DC input
USB USB Port
  • Max Dimensions: 6cm x 2cm x 1.1 cm
  • Interface: USB 2.0
  • Connector: USB – Type-A plug