R550

The R550 is a 2x2:2, dual-band, 802.11ax Access Point with internal BeamFlex and adaptive antennas technology for carriers and enterprises.
Note: The minimum software revision for the R550 is SmartZone (SZ) 5.2 new AP model patch and ZoneDirector (ZD) 10.4.1 native support.

Front View Features

The R550 includes five LEDs on its front panel and buttons and connectors on its rear panel.

R550 front view

R550 front panel elements

LED Description
PWR LED
  • Off: Off.
  • Red: Boot up in process.
  • Green: On.
CTL LED
  • Off: The AP is not being managed by a controller (standalone mode).
  • Green: The AP is being managed by a controller.
  • Slow flashing green (one flash every two seconds): The AP is being managed by a controller, but is currently unable to communicate with the controller.
  • Fast flashing green (two flashes every second): The AP is being managed by a controller and is currently receiving configuration settings (provisioning) or an image update.
AIR LED
  • Off: The AP is operating in standalone mode or operating as a root AP (RAP) or a non-mesh AP
  • Green: The AP is functioning as a Mesh AP (MAP), and the wireless signal to its uplink AP is good.
  • Slow flashing green (one flash every two seconds): Mesh networking is enabled, but the AP is still searching for a mesh uplink.
  • Fast flashing green (two flashes every second): The AP is functioning as a Mesh AP (MAP), and the wireless signal to its uplink AP is fair.
2.4G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated.
5G LED (WLAN)
  • Off: The WLAN service is down.
  • Green: The WLAN service is up and at least one client is associated.
  • Amber: The WLAN service is up and no clients are associated. Fast flashing green (two flashes every second): The WLAN service is up, at least one downlink MAP is connected, and at least one client is associated.

Rear Panel Features

The rear panel of the R550 includes one 10/100/1000 PoE Ethernet port, power socket and reset button. See the table below for a description of each rear panel part.

R550 rear panel

R550 bottom panel elements

Item Name Description
10/100/1000+ non-PoE Port One RJ-45 port for a 10/100/1000 non-PoE connection.
10/100/1000+ PoE Port One RJ-45 port for a 10/100/1000 (802.3af/at PoE) connection.
USB USB port
  • Maximum Dimensions: 6 cm x 2 cm x 1.1 cm
  • Interface: USB 2.0
  • Connector: USB – Type-A plug
RST Button Pressing, and then quickly releasing this internal button reboots the AP. Pressing and holding it for six seconds resets the AP to factory default settings.
Note: Resetting the AP to factory default settings erases all previously configured settings.
Power Connect the power adapter (12 VDC) to this socket. Power can also be supplied via the 10/100/1000 PoE port.