Step 1: Preconfiguring the AP

Preconfigure the AP for standalone operation, for management by FlexMaster, or for management by a Ruckus ZoneDirector or SmartZone controller.

The 100.0.0 and later APs are shipped from the factory with an AP base image that supports standalone and FlexMaster-managed operation, but does not support SmartZone or ZoneDirector controller operation. After you have configured the AP with the base image as described in the following sections, the AP automatically attempts to discover any operator-defined controllers. If the AP finds a controller that is configured to automatically recognize the AP, then the AP downloads the controller-specific AP firmware from the controller. If the AP does not find a controller, it retains its base image AP firmware.

Note: If the AP has been configured with SmartZone or ZoneDirector controller-specific AP firmware, it retains that image after a factory reset. To replace a controller-specific AP image with the standalone AP firmware, download the specific AP image from https://support.ruckuswireless.com and perform an upgrade from the AP web interface.

The procedure for completing the AP's basic configuration depends on whether you want it to be managed by SmartZone, ZoneDirector, FlexMaster, or to operate as a standalone AP. Refer to the section that is relevant to your deployment: