Configuring PPPoE

Use the following procedure to configure PPPoE addressing for the AP.
Point to Point Protocol over Ethernet (PPPoE) is a Layer 2 protocol which uses the PPP (Point to Point) protocol to connect a client system to a server system over a one to one network link. All traffic for a PPPoE-connected client must go through the PPPoE server to reach the client. A PPPoE server can therefore be used to route, NAT, firewall, and perform QoS traffic shaping.

If a PPPoE server is used to distribute internet access to subscribers, the AP can be configured with a PPPoE username and password to authenticate with the PPPoE server.

PPPoE is available only for the IPv4 connection type; PPPoE is not supported in IPv6 environments.

  1. Go to Configuration > Internet.
  2. Under IPv4 Connection Type select PPPoE.
  3. Enter a PPPoE Username.
  4. Enter a PPPoE Password.
  5. Retype the password in PPPoE Password Confirmation.
  6. To allow the DNS mode to be determined automatically, set IPV4 DNS Mode to Auto.
  7. To set the DNS mode manually, set IPV4 DNS Mode to Manual. Then enter the following:
    • IPv4 Primary DNS Server: The IP address of the primary Domain Name System (DNS) server.
    • IPv4 Secondary DNS Server (optional): The IP address of the secondary DNS server.
  8. Click Update Settings to save your changes.