Using Ruckus Custom Indicators
Packets captured on Ruckus APs include some information that is not available when
capturing from other Wi-Fi devices. This additional information is stored in the Per-Packet
Information (PPI) header that precedes the over-the-air content.
- The PPI:802.11-Common Header antenna signal and antenna noise fields of packets transmitted by the AP contain the next-to-lowest byte and the lowest byte, respectively, of the antenna pattern used to transmit the packet. On some APs, the pattern value may contain more significant bits, which are not stored in this header. If the packet is 802.11n, it will also contain the full antenna pattern value in the header described below.
- The PPI:802.11n-MAC+PHY Header EVM-3 field of packets transmitted by the AP contains the full antenna pattern used to transmit the packet (similar to above, except this 32-bit field can accommodate the complete value).
- The PPI:802.11n-MAC+PHY Header MAC Flags field’s upper bits convey additional TX and RX descriptor indicators described in the table below.
Ruckus-defined indicators conveyed in MAC Flags
| TX Indicator | Bit | RX Indicator |
|---|---|---|
| Sounding (0=not; 1=yes) | 31 | Sounding (0=not; 1=yes) |
| TxBF (0=not applied; 1=yes) | 30 | unassigned |
| Ness (#ext spatial streams) | 28-29 | Ness (#ext spatial streams) |
| STBC (0=not applied; 1=yes) | 27 | STBC (0=not applied; 1=yes) |
| LDPC (0=not applied; 1=yes) | 26 | LDPC (0=not applied; 1=yes) |
| LDPC indicator valid | 25 | LDPC indicator valid |
| unassigned | 24 | unassigned |
| RTS HTC TRQ | 23 | HW Upload Data |
| RTS HTC MRQ | 22 | HW Upload Data Valid |
| RTS HTC MSI | 20-21 | HW Upload Data Type |
| RTS enabled | 19 | unassigned |
| Calibrating | 18 | unassigned |
Limitation: The AP can report RX EVM values or the RX LDPC indicator, but not both. When packet capture is invoked from the ZD UI, the software selects RX EVM values. Therefore, the RX LDPC indicator is not reported, and the LDPC indicator valid bit will be zero. The RX LDPC indicator is available when invoking packet capture from the AP command line interface.