Setting Up Email Alarm Notifications

If an alarm condition is detected, ZoneDirector will record it in the event log. If you prefer, an email notification can be sent to a configured email address of your choosing.
To activate this option, follow these steps:
  1. Go to System > Email Alarm Settings.
  2. To enable email notification, select the Send an email message when an alarm is triggered check box.
  3. Enter the recipient email address in the Email Address box provided, and click Apply.
  4. Go to System > System Settings, and scroll down to the Email Server section.
  5. Configure the settings listed in the following SMTP settings for email notification table.
    SMTP Setting Description
    From email address Type the email address from which ZoneDirector will send alarm messages.
    SMTP Server Name Type the full name of the server provided by your ISP or mail administrator. Often, the SMTP server name is in the format smtp.company.com. For Hotmail addresses, the SMTP server name is smtp.live.com.
    SMTP Server Port Type the SMTP port number provided by your ISP or mail administrator. Often, the SMTP port number is 25 or 587. The default SMTP port value is 587.
    SMTP Authentication Username Type the user name provided by your ISP or mail administrator. This might be just the part of your email address before the @ symbol, or it might be your complete email address. If you are using a free email service (such as Hotmail or Gmail), you typically have to type your complete email address.
    SMTP Authentication Password Type the password that is associated with the user name above.
    Confirm SMTP Authentication Password Retype the password you typed above to confirm.
    SMTP Encryption Options If your mail server uses TLS encryption, click the SMTP Encryption Options link, and then select the TLS check box. Additionally, select the STARTTLS check box that appears after you select the TLS check box. Check with your ISP or mail administrator for the correct encryption settings that you need to set. If using a Yahoo! email account, STARTTLS must be disabled. If using a Hotmail account, both TLS and STARTTLS must be enabled.
  6. To verify that ZoneDirector can send alarm messages using the SMTP settings you configured, click the Test button.
    • If ZoneDirector is able to send the test message, the message Success! appears at the bottom of the Email Notification page. Continue to Step 7.
    • If ZoneDirector is unable to send the test message, the message Failed! appears at the bottom of the Email Notification page. Go back to Step 5, and then verify that the SMTP settings are correct.
  7. Click Apply. The email notification settings you configured become active immediately.
    Note: If the Test button is clicked, ZoneDirector will attempt to connect to the mail server for 10 seconds. If it is unable to connect to the mail server, it will stop trying and quit.
    Note: When the alarm email is first enabled, the alarm recipient may receive a flood of alarm notifications. This may cause the mail server to treat the email notifications as spam and to temporarily block the account.
    Note: ZoneDirector sends email notifications for a particular alert only once, unless (1) it is a new alert of the same type but for a different device, or (2) existing alert logs are cleared.