Onboarding Mesh APs with Zero Touch Mesh

To allow Mesh APs to join the Mesh network without first connecting them via Ethernet, use the following procedure:
  1. Go to Services & Profiles > Mesh.
  2. Select the check box to enable Zero Touch Mesh.
  3. Click Apply. The changes to the mesh settings will propagate through the mesh network.
  4. Go to Access Points.
  5. When a supported AP attempts to join, it will appear in Disconnected state in the AP table. Click the Approve button to approve the AP.
  6. To pre-approve APs by serial number, go to Services & Profiles > Mesh > Zero Touch Mesh, and locate the Pre-Approved Zero Touch Mesh section.
  7. In the same section, click the Add button to add a new AP or multiple APs to the list of pre-approved Zero Touch Mesh APs.
    The Input AP Serial Number window appears.
  8. Enter the AP Serial Numbers of the APs to auto-provision, and click OK.
    Note: You can enter multiple serial numbers. Each serial number must be exactly 12 characters (no colons), and each must be on its own separate line. You can also copy/paste many serial numbers from a text editor. Empty lines are invalid.
    The AP serial numbers are added to the list.
  9. Click Apply. A message box appears notifying you that the process may take several minutes for the changes to propagate through the mesh network.
  10. When the listed APs in factory default state come online, they will begin performing network discovery, auto-provisioning and finally association to another upstream AP on the network.