Understanding Mesh-related AP Statuses

You can use the Access Points page for viewing and mesh-related AP statuses.

In the Access Points table, the mesh status of each AP is displayed in the Status column, along with the Mesh Mode and other details.

The table below lists possible AP statuses that are related to mesh networking in the Status column, including any actions that you may need to perform to resolve mesh-related issues.

Status Description Recommended Action
Connected AP is connected to ZoneDirector, but mesh is disabled If mesh is enabled on the AP, you may need to reboot it to activate the mesh.
Connected (Root AP) AP is connected to ZoneDirector via its Ethernet port
Connected (Mesh AP, n hops) AP is connected to ZoneDirector via its wireless interface and is n hops away from the Root AP.
Connected (eMesh AP, n hops AP is connected to ZoneDirector via its Ethernet port, but acts as a Mesh AP using another Mesh AP as its uplink
Isolated Mesh AP AP is disconnected from the ZoneDirector mesh
  • The AP may be configured incorrectly. Verify that the mesh SSID and passphrase configured on the AP are correct.
  • If Uplink Selection is set to Manual, the uplink AP specified for this AP may be off or unavailable.