Configuring AP Ethernet Ports

You can use AP groups to control Ethernet ports on all APs of a certain model. Then, if you want to override the port settings for a specific AP, you can do so as explained in the Managing Access Points Individually section below.
To configure Ethernet ports for all APs of the same model:
  1. Go to Access Points
  2. In Access Point Groups, click Edit for the group you want to configure.
  3. Locate the Model Specific Control section, and select the AP model that you want to configure from the list.
  4. In Port Setting, click Edit Port Setting. The screen changes to display the Ethernet ports on the AP model currently selected.
  5. Deselect the check box next to Enable to disable this LAN port entirely. All ports are enabled by default.
  6. Select the check box next to Tunnel to tunnel all Ethernet traffic on this access port to ZoneDirector.
    By default, Ethernet traffic is bridged to the network at the AP, rather than tunneled to ZoneDirector. In some specific scenarios (such as Point of Sales and hotel room applications), tunneling Ethernet traffic to ZoneDirector may be preferable.
    Note: Note that enabling port tunneling may impact wireless performance. Additionally, some features are not available for tunneled Ethernet traffic, including client fingerprinting, application visibility, SpeedFlex performance testing, etc. Therefore, Ruckus recommends against enabling port tunneling except in specific cases where it is needed.
  7. Select DHCP_Opt82 if you want to enable this option for this port (see DHCP Option 82).
  8. For any enabled ports, you can choose whether the port will be used as a Trunk Port, an Access Port or a General Port. The following restrictions apply:
    • All APs must be configured with at least one Trunk Port.
    • For single port APs (e.g., R310), the single LAN port must be a Trunk Port and is therefore not configurable.
    • For Wall Plate APs (such as the H510), the LAN5/Uplink port on the rear of the AP is defined as a Trunk Port and is not configurable. The front-facing LAN ports are configurable.
    • For all other APs, you can configure each port individually as either a Trunk Port, Access Port or General Port. (See Designating Ethernet Port Type for more information.)
  9. (If Smart Mesh is not enabled), choose whether this port will serve as an 802.1X Authenticator or Supplicant, or leave 802.1X settings disabled (default). (See Using Port Based 802.1X for more information.)
  10. Click Apply to save your changes.