RADIUS Attributes

Ruckus products communicate with an external RADIUS server as a RADIUS client. Packets from Ruckus products are called "access-request" or "accounting-request" messages. The RADIUS server, in turn, sends an "access-challenge", "access-accept" or "access-reject" message in response to an access-request, and an "accounting-response" message in response to an accounting-request.

RADIUS Attribute Value Pairs (AVP) carry data in both the request and the response messages. The RADIUS protocol also allows vendor specific attributes (VSA) to extend the functionality of the protocol. The following tables list the RADIUS attributes used in these messages between ZoneDirector and the RADIUS/RADIUS Accounting server based on which type of authentication is used for the WLAN.

ZoneDirector will terminate a user session if it receives a Change of Authorization-Disconnect Message (COA-DM) from the RADIUS server. The COA-DM message may be used when a client changes service levels. For instance, a new user may initially connect to a free, low-rate service on one WLAN. When they purchase access on a higher-rate service, RADIUS will send a COA-DM message to ZoneDirector, causing the user to re-connect to an alternative WLAN. COA-DM may also be used to remove a client if a user exceeds their total bandwidth allowance or time on the network.

Note: In addition to COA-DM messages, as of release 10.0, ZoneDirector also supports the following COA messages:
  • Idle timeout
  • Session Timeout
  • Accounting interval
  • Uplink rate limit
  • Downlink rate limit
  • Filter ID (ACL ID)

Notation "==>" below indicates this value is generated external to AP/ZoneDirector.

  • In the case of EAP payload, this is generated by a wireless client and encapsulated in the RADIUS access-request packet.
  • In the case of a "state" attribute, it indicates that an access-request packet is a response to the last received access-challenge packet by copying the "state" AVP unmodified.
  • As for the "class" attribute, it is parsed and stored from an access-accept packet and then subsequently used in accounting-request packets.