Step 3: Provision and Deploy Mesh Nodes
In this step, you will connect each AP to the same wired network as ZoneDirector to
provision it with mesh-related settings. After you complete provisioning an AP, you
must reboot it for the mesh-related settings to take effect.
Note: Beginning with release 10.2, ZoneDirector also provides a "Zero Touch Mesh" option,
which alleviates the need to perform this manual provisioning procedure. For more
information, see
Zero Touch Mesh.
To provision and deploy a mesh node:
- Using one of the AP's Ethernet ports, connect it to the same wired network to which ZoneDirector is connected, and then power it on. The AP detects ZoneDirector and sends a join request.
- If Auto Approval is enabled, continue to Step 3. If Auto Approval is disabled, log into ZoneDirector, check the list of currently active access points for the AP that you are attempting to provision, and then click the corresponding Allow link to approve the join request.
- After the AP has been provisioned, disconnect it from the wired network, unplug the
power cable, and then move the device to its deployment location.
- If you want the AP to be a Root AP, reconnect it to the wired network using one of its Ethernet ports, and then power it on. When the AP detects ZoneDirector again through its Ethernet port, it will set itself as a Root AP, and then it will start accepting mesh association requests from Mesh APs.
- If you want the AP to be a Mesh AP, power it on but do not reconnect it to the wired
network. When it does not detect ZoneDirector through its Ethernet port within 90
seconds, it will search for potential uplink APs and, once mesh neighbor relationships
are established, form a mesh tree.
Note: After an AP in its factory default state has been provisioned, you need to reboot it to enable mesh capability.Note: If you are located in the United States and have a DFS-capable AP that is expected to serve as a Root AP (or eMAP), with a non-DFS-capable Mesh AP as its downlink, you will need to set the channel for the Root AP to one of the non-DFS channels. Specifically, choose one of the following channels: 36, 40, 44, 48, 149, 153, 157, 161, 165. This is due to the DFS-capable AP’s ability to use more channels than the non-DFS-capable AP, which could result in the RAP choosing a channel that is not available to the MAP. Alternatively, go to System > System Settings > Country Code, and set the Channel Optimization setting to “Optimize for Compatibility.”