Modifying the System Default AP Group
- Go to Access Points.
- In the Access Point Groups section on the left side of the screen, select the System Default access point group, and click the Configure button. The Edit AP Group form appears.
- Modify any of the settings in the following table that you want to apply to the System
Default AP group, and click
OK to save your changes.
Setting Description Name The System Default group name cannot be changed (you can edit this field when creating/editing any other AP group). Description The System Default description cannot be changed (you can edit this field when creating/editing any other AP group). Channel Range Settings To limit the available channels for 2.4 GHz, 5 GHz Indoor and 5 GHz Outdoor channel selection, deselect any channels that you do not want the APs to use. Note: For country codes "US" and "JP", channel 144 is supported if DFS channel is enabled.Channelization Select Auto, 20 MHz or 40 MHz channel width for the 2.4 GHz radio, or Auto, 20, 40, or 80 MHz channel width for the 5 GHz radio. Channel Select Auto or manually assign a channel for the 2.4 GHz or 5 GHz radio. Tx Power Allows you to manually set the transmit power on all 2.4 GHz or 5 GHz radios (default is Auto). Max = max allowable Tx power according to country regulations
Min = 0dBm per chain for 11n APs, 2dBm per chain for 11ac APs
WLAN Group Specify which WLAN group this AP group belongs to. Call Admission Control (Disabled by default). Enable Wi-Fi Multimedia Admission Control (WMM-AC) to support Polycom/Spectralink VIEW certification. WLAN Service This option allows users to disable WLAN service on the 2.4 or 5 GHz radios on all APs in the AP group. Protection Mode If you activate Protection Mode, you control how 802.11 devices know when they should communicate with another device on the 2.4 GHz radio. The use of RTS/CTS (Request to Send/Clear to Send) reduces collisions and increases the performance of the network if hidden stations are present. However, RTS/CTS (and CTS-only) introduce overhead and may in fact reduce overall performance in some situations. Through the proper use of RTS/CTS and CTS-only, you can fine-tune the operation of your wireless LAN depending on the physical operating environment. CTS-only: Choose this option to force all destination devices to acknowledge their ability to receive data when a transmission is initiated. Use this option for compliance with the Wi-Fi Alliance certification.
RTS/CTS: Choose this option to force both sending and receiving devices to confirm a data exchange on both ends before proceeding.
None: Choose this option to disable both RTS and CTS acknowledgment.
IP Mode Set IPv4, IPv6 or dual-stack IPv4/IPv6 IP addressing mode. Location Service Enable this option to enable ZoneDirector's share in the RUCKUS SmartPositioning Technology (SPoT) location based service solution. Select the Venue Name that you created on the Services & Profiles > Location Services page. See SPoT Location Services. For information on configuration and administration of Ruckus SmartPositioning Technology (SPoT) service, refer to the SPoT User Guide, available from the RUCKUS support site: https://support.ruckuswireless.com. Model Specific Control Use this section to configure max clients, LEDs and port settings for all APs of each specific model that are members of the group. See Modifying Model Specific Controls. Group Settings The Group Settings section is used to move access points between groups. See Modifying Access Point Group Membership.