AP Ethernet Port as Authenticator

The Access Point is similar in many ways to a wireless switch. On APs with two or more wired ports, the AP acts as a network edge switch and can be configured to authenticate downstream wired stations (which could include multiple clients connected to another edge switch).

When the AP Ethernet port is configured as an 802.1X authenticator, it can be further defined as either Port-based or MAC-based. MAC-based authenticator mode is only supported if the port is an Access Port.

Authenticator support vs. Port Type

  Trunk Port Access Port General Port
Port-based mode X X X
MAC-based mode   X  
To configure an AP Ethernet port as an 802.1X authenticator:
  1. Go to Access Points and click the Configure icon for the AP whose ports you want to configure.
  2. Locate the Port Setting section and select Override Group Config. The screen changes to display the AP's Ethernet ports.
  3. For Type, select Access Port.
  4. For 802.1X, select Authenticator (MAC-based) or Authenticator (Port-based).
    • In Port-based mode, only a single MAC host must be authenticated for all hosts to be granted access to the network.
    • In MAC-based mode, each MAC host is individually authenticated. Each newly-learned MAC address triggers an EAPOL request-identify frame.
      • Guest VLAN: (Default disabled). When a station fails to authenticate to this port, it will be assigned to this “guest” VLAN, with access to Internet but not to internal resources.
      • Dynamic VLAN: (Default disabled). Dynamically assign VLANs based on the policies set on the RADIUS server.
      • Authenticator: Select the RADIUS server from the list. A RADIUS server must be selected to set this port as a MAC-based authenticator.
  5. Enable MAC authentication bypass: Enable this option to allow AAA server queries using the MAC address as both the user name and password. If MAC authentication is unsuccessful, the normal 802.1X authentication exchange is attempted.