Creating a Bonjour Gateway Rule AP Site

Using the AP Site Bonjour Gateway feature, Bonjour bridging service is performed on a designated AP rather than on ZoneDirector.

Offloading the Bonjour policy to an AP is necessary if a Layer 3 switch or router exists between ZoneDirector and the APs. ZoneDirector identifies a single AP that meets the memory/processor requirements (this feature is only supported on certain APs), and delivers a set of service rules - a Bonjour policy - to the AP to perform the VLAN bridging.

Requirements and limitations:

  • Bonjour policy deployment to an AP takes effect after the AP joins ZoneDirector.
  • Some APs of one local area link must be in one subnet. The switch interfaces connected to these APs in a local area link to must be configured in VLAN-trunk mode. Only by doing so can the designated AP can receive all the multicast Bonjour protocol packets from other VLANs.
  • Dynamic VLANs are not supported.
  • Some AP models are incompatible with this feature due to memory requirements.

To configure rules for AP site bridging Bonjour services across VLANs:

  1. Go to Services & Profiles > Bonjour.
  2. In the Bonjour Service on AP Site section, click Create New to create a new Bonjour service policy.
  3. Type a name for the policy, then click Create New to create a new rule.
  4. In the Create New form, configure the following options:
    • Name: Enter a name for the proxy.
    • Description: Optionally, enter a description for the rule.
    • Order: Choose the order in which to apply rules.
    • Bridge Service: Select the Bonjour service from the list.
    • From VLAN: Select the VLAN from which the Bonjour service will be advertised.
    • To VLAN: Select the VLAN to which the service should be made available.
    • Notes: Add optional notes for this rule.
  5. Click OK to save your changes.
  6. Repeat for any additional rules.
  7. Select the check box next to Enable Bonjour gateway on AP and click the OK button.