Creating Layer 3/Layer 4/IP Address Access Control Lists

In addition to L2/MAC based ACLs, ZoneDirector also allows you to create access controls at Layer 3 and Layer 4.

These controls can be applied based on a set of criteria including:

  • Source Address
  • Destination Address
  • Application
  • Protocol
  • Source Port
  • Destination Port

To create an L3/L4/IP address based ACL:

  1. Go to Services & Profiles > Access Control.
  2. Expand the L2-L7 Access Control section.
  3. In L3/4/IP address Access Control, click Create New.
    Note: Alternatively, you can create a Layer 3/Layer 4/IP Address ACL from the WLAN creation page while creating a new WLAN or modifying an existing WLAN (Wireless LANs > Edit > Advanced Options > Access Control > L3/4/IP Address > Create.)
  4. Type a Name for the ACL.
  5. Type a Description for the ACL.
  6. In Default Mode, set the default action to perform if no rule is matched.
  7. In Rules, click Create New or click Edit to edit an existing rule.
  8. Define each access rule by configuring a combination of the following:
    • Type: The access privilege (allow or deny) that this rule grants.
    • Source Address: Enter a source IP address from which to allow or block traffic. IP address must be in the format A:B:C:D/M, where M is the netmask. To allow/deny a single host, use /32 as the netmask.
    • Destination Address: Enter an IP subnet and netmask of the network target to which you want to allow or deny access. IP address must be in the format A.B.C.D/M, where M is the netmask. To allow/deny a single host, use /32 as the netmask.
    • Application: If you select a specific application from the menu, the Protocol and Destination Port options are automatically filled with the relevant values and are not configurable.
    • Protocol: Enter a network protocol number (0-254), as defined by the IANA (http://www.iana.org/assignments/protocol-numbers/protocol-numbers.xhtml) to allow or deny. Otherwise, select Any.
    • Source Port: Enter a valid port number (1-65534) or port range (e.g., 80-443).
    • Destination Port: Enter a valid port number (1-65534) or port range (e.g., 80-443).
  9. Click OK to save the ACL.
  10. Repeat these steps to create up to 32 L3/L4/IP address-based access control rules.