Configuring Client Isolation White Lists

When Wireless Client Isolation is enabled on a WLAN, all communication between clients and other local devices is blocked at the Access Point. To prevent clients from communicating with other nodes, the Access Point drops all ARP packets from stations on the WLAN where client isolation is enabled and which are destined to IP addresses that are not part of a per-WLAN white list.

You can create exceptions to client isolation (such as allowing access to a local printer, for example) by creating Client Isolation White Lists.

To create a Client Isolation White List:

  1. Go to Services & Profiles > Access Control > Client Isolation Whitelist.
  2. Expand the Client Isolation White List section, and click Create New.
    Note: You can also create a Client Isolation White List while creating a WLAN from within the WLAN configuration screen (Wireless LANs > Create New > Wireless Client Isolation > Create New).
  3. Enter a Name and optionally a Description for the access policy.
  4. In Rules, you can create multiple device-specific rules for each device to be white listed.
    • Description: Description of the device.
    • MAC Address: Enter the MAC address of the device.
    • IPv4 Address: Enter the IP address of the device.
  5. Click Save to save the rule you created.
  6. To change the order in which rules are implemented, select the order from the drop-Order column. You can also Edit or Clone rules from the Action column. To delete a rule, select the box next to the rule and click Delete.
  7. Click OK to save the white list.

To apply a Client Isolation White List to a WLAN:

  1. Go to Wireless LANs.
  2. Click Edit next to the WLAN you want to edit.
  3. In Wireless Client Isolation (under Options), select the level of client isolation you want to enforce:
    • Isolate wireless client traffic from other clients on the same AP: Enable client isolation on the same Access Point (clients on the same subnet but connected to other APs will still be able to communicate).
    • Isolate wireless client traffic from all hosts on the same VLAN/subnet: Prevent clients from communicating with any other hosts on the same subnet or VLAN other than those listed on the Client Isolation Whitelist. If this option is chosen, you must select a Whitelist from the drop-down list of those you created on the Services & Profiles > Access Control page.
  4. Click OK to save your changes.