Configuring Global Access Point Policies
The Access Point Policies options allow you to define how new APs are detected and
approved for use in WLAN coverage, as well as policies on ZoneDirector discovery and
communicating with ZoneDirector.
These policies are enforced on all APs managed by ZoneDirector unless a specific WLAN setting overrides them. For example, if you want to enable Load Balancing for most APs but disable it on specific WLANs, you would enable it in the Access Point Policies section, then disable it for the particular WLAN from the Wireless LANs page.
To review and revise the general AP policies, follow these steps:
- Go to System > AP General Settings.
- Review the current settings in
Access Point Policies. You can change the following settings:
- Approval: This is enabled by default, which means that all join requests from any Ruckus AP will be approved automatically. If you want to manually review and approve the joining of new APs to the WLAN, clear this check box.
- Limited ZoneDirector Discovery: If you have multiple ZoneDirectors on the network and want specific APs to join
specific ZoneDirectors, you can limit ZoneDirector discovery. To do this, select the
Limited ZD Discovery check box, and then enter the IP addresses (or FQDN) of the primary and secondary
ZoneDirector units to which you want APs to join. When
Limited ZD Discovery is enabled, APs will first attempt to join the primary ZoneDirector. If they cannot
find or are unable to join the primary ZoneDirector, they will attempt to join the
secondary ZoneDirector. If still unsuccessful, APs will stop attempting for a brief
period of time, and then they will restart the joining process. They will repeat this
process until they successfully join either the primary or secondary ZoneDirector.
Note: If you have two ZoneDirectors of the same model, Ruckus recommends using the Smart Redundancy feature. If you have two ZoneDirectors of different models, you can use Limited ZD Discovery to provide limited redundancy; however, this method does not provide synchronization of the user database. For information on Smart Redundancy configuration, see Enabling Smart Redundancy. For information on N+1 redundancy using Limited ZD Discovery, see Using Limited ZD Discovery for N+1 Redundancy.
-
- Prefer Primary ZD: Enable this option if you want APs to revert to the primary ZoneDirector’s control after connection to the primary controller is restored.
- Keep AP's Primary and Secondary ZD Settings: Enable this option if you want the AP's existing settings to take precedence (not be overwritten by secondary controller's settings after failover to secondary ZD).
- Management VLAN: You can enable the ZoneDirector management VLAN if you want to separate management traffic from regular network traffic. The following options are available:
- Load Balancing: Balances the number of clients across adjacent APs (see Load Balancing).
- Tunnel MTU: Use this field to set the Maximum Transmission Unit for tunnel packets between ZoneDirector and APs. The MTU is the size of the largest protocol data unit (in bytes) that can be passed. Supported MTU values range from 850 to 1500 (default is 1500). Note that changing this setting to a value less than 1280 will affect IPv6 connectivity.
- Auto Recovery: Set an AP auto recovery time in minutes, after which APs will reboot in attempt to reconnect to ZoneDirector. Default is 30 minutes.
- Click
Apply to save and apply your settings.