termination-date

Sets the end date for recurring time profile execution.
Syntax
termination-date end-date
no termination-date end-date
Parameters
end-date
Specifies the end date. Date must be specified in the MM-DD-YYYY or MM-DD-YY format.
Modes

Time-profile-configuration mode

Usage Guidelines

The termination date configuration is not mandatory for the recurring profile execution; the profile will simply run in perpetuity.

The termination date configuration is not used for a one-time profile execution.

During configuration of the time-profile, you may enter the termination-date command at any point prior to entering the schedule command.

The no form of this command deletes the termination date configuration.

Examples

The following example shows how to create a recurring time profile named "profile1", configuring the profile to execute the added commands, and scheduling the profile to run on the 5th and 10th of every month beginning August 12, 2024, and ending October 12, 2024.

device# configure terminal
device(config)# time-profile profile1
device(config-time-profile-profile1)# start-date 08-12-24
device(config-time-profile-profile1)# repeat monthly 5,10
device(config-time-profile-profile1)# termination-date 10-12-24
device(config-time-profile-profile1)# command-list
device(config-time-profile-profile1-command-list)# add "port-speed auto"
device(config-time-profile-profile1-command-list)# add "ports eth 1/1/2 to 1/1/8"
device(config-time-profile-profile1-command-list)# exit
device(config-time-profile-profile1)# execution-time 09:30
device(config-time-profile-profile1)# schedule
History
Release version Command history
10.0.20a This command was introduced.
Parent topic: Commands Si - Z