anycast-gw-mac
An anycast gateway MAC address is not configured for a VE interface.
Interface subtype configuration mode
This command is not supported for ICX 8200 devices.
This command is supported for VE interfaces
only. Before configuring the anycast gateway, the VE interface must be configured
with overlay VRF (using the vrf forwarding overlay-vrf command)
and an IP address and subnet mask (using the ip address
command).
The no form of the command
removes a configured anycast gateway MAC address for the VE interface.
The following example configures two VE interfaces with the same anycast gateway MAC address in a VXLAN environment.
device# configure terminal device(config)# interface ve 5 device(config-vif-5)# vrf forwarding overlay-vrf device(config-vif-5)# ip address 100.1.1.1/24 device(config-vif-5)# anycast-gw-mac aabb.ccdd.eeff device# configure terminal device(config)# interface ve 6 device(config-vif-6)# vrf forwarding overlay-vrf device(config-vif-6)# ip address 101.1.1.1/24 device(config-vif-6)# anycast-gw-mac aabb.ccdd.eeff
| Release version | Command history |
|---|---|
| 10.0.20a | This command was introduced. |