sa-limit in

By default the device uses 4096 as the source active message limit for peers. Use this command to change the source active message limit between peers.

Syntax

sa-limit in {peer-ip | max-sa}

Command Default

Source Active message limit is not configured.

Parameters

peer-ip: Specifies the IP address of the MSDP neighbor that the SA messages are sent to or received from.
max-sa: Specifies the value that you want to set as a maximum number of SA messages in the peer SA cache. Allowed values are 1024 to 8192. The default is 4096 messages.
Note: Ensure that you select a value that is equal to or less than the maximum SA messages limit configured at the global level. Use the show ip msdp peercommand to display the Input SA-CACHE limit value configured at the global-level.

Modes

Router MSDP configuration mode

Usage Guidelines

Use this command if you want to configure an SA message limit to a specific peer that is less than the global SA limit.

The no form of this command removes the SA peer limit.

Examples

The following example sets the source active message limit between peers.

device# configure terminal
device(config)# interface loopback 1
device(config-lbif-1)# ip address 10.9.9.9/32
device(config-lbif-1)# exit
device(config)# router msdp
device(config-msdp-router)# msdp-peer 205.216.162.1 connect-source loopback 1
device(config-msdp-router)# sa-limit in 205.216.162.1 3000

History

Release version	Command history
10.0.20a	This command was introduced.

RUCKUS FastIron Command Reference Guide, 10.0.20 53-1005798-23

sa-limit in