cluster-id

Configures a cluster ID for the route reflector.
Syntax
cluster-id { num | ip-addr}
no cluster-id { num | ip-addr}
Command Default

The default cluster ID is the device ID.

Parameters
num
Integer value for cluster ID. Range is from 1 through 65535.
ip-addr
IPv4 address in dotted-decimal notation.
Modes

BGP configuration mode

BGP L2VPN EVPN address family configuration mode

Usage Guidelines

When configuring multiple route reflectors in a cluster, use the same cluster ID to avoid loops within the cluster.

Note: The cluster ID is shared for all Virtual routing and forwarding (VRF) instances.

This command can be configured in BGP L2VPN EVPN address family configuration mode for RUCKUS ICX 7850 and ICX 7550 devices only.

The no form of the command restores the default.

Examples

The following example configures a cluster ID for the route reflector. 

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# cluster-id 1234

The following example configures a cluster ID for the route reflector in BGP L2VPN EVPN configuration mode. 

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 656
device(config-bgp-router)# neighbor 1.1.1.35 remote-as 656
device(config-bgp-router)# address-family l2vpn evpn
device(config-bgp-l2vpn-evpn)# neighbor 1.1.1.35 activate
device(config-bgp-l2vpn-evpn)# neighbor 1.1.1.35 send-community both
device(config-bgp-l2vpn-evpn)# cluster-id 1234
Release version Command history
10.0.20 This command can also be configured in BGP L2VPN EVPN address family configuration mode.
Parent topic: Commands C