jitter threshold

Configures the maximum allowable jitter for validation purposes for an IP Performance Metrics (IPPM) profile.
Syntax
jitter threshold value probe-count count
no jitter threshold value probe-count count
Command Default

The jitter threshold for the target host is not configured.

Parameters
value
Specifies the maximum value for allowable jitter in milliseconds. Valid values range from 1 through 200.
probe-count count
Specifies the probe count. Valid values range from 3 through 10. The default probe count is 3.
Modes

IPPM profile configuration mode

Usage Guidelines

If no probe count is specified, the default of 3 is used.

The no form of the command removes the configured jitter threshold from the profile.

Examples

The following example configures the maximum allowable jitter for an IPPM profile to 12 milliseconds. No probe count is specified, so the default probe count of 3 is configured.

device# configure terminal
device(config)# jitter threshold 12
Jitter validation is performed with default probe_count of 3...

The following example configures the maximum allowable jitter for an IPPM profile to 12 milliseconds. A probe count 5 is configured.

device# configure terminal
device(config)# ippm profile test1 type icmp-echo
device(config-icmp-echo-test1)# jitter threshold 12 probe-count 5
History
Release version Command history
10.0.20 This command was introduced.
Parent topic: Commands J, K, and L