evpn-instance range

Configures a range of Layer 2 Ethernet Virtual Private Network (EVPN) instances.
Syntax
evpn-instance range instance-id start to instance-id end vni-start vni-value vlan-based
no evpn-instance range instance-id start to instance-id end vni-start vni-value vlan-based
Command Default

There are no Layer 2 Ethernet Virtual Private Network (EVPN) instances by default.

Parameters
range instance-id start
Specifies the starting ID for the range of EVPNs in this instance. Valid values range from 1 through 4294967295.
to instance-id end
Specifies the ending ID for the range of EVPNs in this instance. Valid values range from 1 through 4294967295.
vni-start vni-value
Specifies the ID for the VNI associated with the first EVPN instance in the defined range. The VNI ID for each subsequent EVPN in the range will increment by 1. Valid values range from 1 through 16777215.
vlan-based
Enables VLAN-based VXLAN.
Modes

EVPN configuration mode

Usage Guidelines

The dependent VLAN-to-VNI mapping has to be configured as part of the VXLAN overlay configuration.

This command is supported for RUCKUS ICX 7850 and ICX 7550 devices only.

The no form of the command removes a range of Layer 2 EVPN instances.

Examples

The following example configures a range of Layer 2 EVPN instances and specifies that a VNI is started.

device# configure terminal
device(config)# l2vpn evpn
device(config-evpn)# evpn-instance range 100 to 200 vni-start 1000 vlan-based
device(config-evpn-evi-range-100-200)#
History
Release version Command history
10.0.20 This command was introduced.
Parent topic: Commands D through H