show ip mroute

Displays information on multicast routes. You can specify whether you want to display information from static or connected mroutes or from a particular mroute.
Syntax
show ip mroute[vrfvrf-name]{static|connected|nexthop|ip-subnet [mask]}
Parameters
vrfvrf-name
Specifies a VRF route.
static
Specifies a static multicast route.
connected
Specifies a directly attached (connected) multicast route.
nexthop
Specifies an IPv4 next hop table.
ip-subnet[mask]
Specifies an IP address.
Modes

Privileged EXEC mode

Global configuration mode

Examples

The following example displays information for IP multicast routes: 

Device(config)# show ip mroute

Total number of IP routes: 5
 Type Codes - B:BGP  D:Connected  S:Static;   Cost - Dist/Metric
        Destination             Gateway              Port             Cost         Type    Uptime
1       20.20.20.0/24           220.220.220.1        ve 220           1/1           S      8m54s 
2       50.50.50.0/24           DIRECT               ve 50            0/0           D      8h26m 
3       77.1.1.1/32             DIRECT               loopback 1       0/0           D      8h26m 
4       129.129.129.0/24        DIRECT               ve 129           0/0           D      8h26m 
5       220.220.220.0/24        DIRECT               ve 220           0/0           D      2h49m

The following example displays information for static multicast routes: 

Device(config)# show ip mroute static

 Type Codes - B:BGP  D:Connected  S:Static;   Cost - Dist/Metric
        Destination              Gateway           Port           Cost   Type   Uptime
1       20.20.20.0/24            220.220.220.1     ve 220         1/1    S      8m54s

The following example displays information for directly attached multicast routes: 

Device(config)# show ip mroute connected

 Type Codes - B:BGP  D:Connected  S:Static;   Cost - Dist/Metric
        Destination             Gateway           Port          Cost   Type   Uptime
1       50.50.50.0/24           DIRECT            ve 50         0/0    D      8h26m 
2       77.1.1.1/32             DIRECT            loopback 1    0/0    D      8h26m 
3       129.129.129.0/24        DIRECT            ve 129        0/0    D      8h26m 
4       220.220.220.0/24        DIRECT            ve 220        0/0    D      2h49m

The following example displays information for IP multicast route 50.50.50.100: 

Device(config)# show ip mroute 50.50.50.100

 Type Codes - B:BGP  D:Connected  S:Static;   Cost - Dist/Metric
        Destination             Gateway           Port          Cost   Type   Uptime
1       50.50.50.0/24           DIRECT            ve 50         0/0    D      8h26m
History
Release version Command history

08.0.10a

This command was introduced.

Parent topic: Show Commands