show inline power debug-info

Displays inline power debug information.

Syntax

show inline power debug-info[stack_unit|unit/slot/port]

Parameters

stack_unit: Displays inline power debug information for the specified stack unit ID.
unit/slot/port: Displays inline power debug information for the specified interface.

Modes

Privileged exec mode

Usage Guidelines

The command prints the complete output of show inline powerport-id plus the last five hardware port states, and the last five software port states.

Examples

Use the following command to display inline power information that is of use in debugging the configuration.

device(config)#show inline power debug-info 2/1/1

Port   Admin   Oper    ---Power(mWatts)---  PD Type  PD Class  Pri  Fault/
        State   State   Consumed  Allocated                          Error
--------------------------------------------------------------------------
  2/1/1 On      On         13200      15400  802.3af  Class 3     3  n/a
 configCmd:Legacy Off, hwEvLatch:0, overdrive:Enabled, pair4En:1
 Last 5 HW port status:
        1:0x1A User OFF                                 2:0x01 af/at PD Detected                  
        3:0x1E Underload State                          4:0x1B Detection in Progress              
        5:0x01 af/at PD Detected                  

Max Power Capability for 2pair PD :45000 mWatts
Highest Power Requested by PD Through LLDP/CDP :n/a

History

Release version	Command history
08.0.50	This command was introduced.
08.0.61	The output was enhanced with PoE overdrive information.
08.0.90	The output was modified to display overdrive and legacy PD detection configuration information.

Show Commands

show inline power debug-info