ipv6 router rip

Enables RIPng globally (on the device).
Syntax
ipv6 router rip
no ipv6 router rip
Command Default

By default, RIPng is disabled.

Modes

Global configuration mode

Usage Guidelines

To disable RIPng globally, use the no form of this command.

Before you can enable RIPng, you must enable forwarding of IPv6 traffic on the device using the ipv6 unicast-routing command.

You must enable IPv6 on each interface on which RIPng is to be enabled. Enable IPv6 explicitly on the interface with the ipv6 enable command or by configuring an IPv6 address on the interface.

After enabling RIPng globally, you must enable it on individual device interfaces using the ipv6 rip enable command. You can enable RIPng on physical as well as virtual routing interfaces.

Examples

The following example enables RIPng on the device. 

device# configure terminal
device(config)# ipv6 router rip
device(config-ripng-router)#
Parent topic: Commands I