include-port

Adds ports to the VSRP.
Syntax
include-port ethernet stackid/slot/port [ to stackid/slot/port | [ ethernet stackid/slot/port to stackid/slot/port | ethernet stackid/slot/port ]... ]
no include-port ethernet stackid/slot/port [ to stackid/slot/port | [ ethernet stackid/slot/port to stackid/slot/port | ethernet stackid/slot/port ]... ]
Command Default

By default, all the ports on which you configure a VRID are interfaces for the VRID.

Parameters
ethernet stackid/slot/port
Adds the Ethernet interface to the VRID.
to stackid/slot/port
Adds a range of Ethernet interfaces to the VRID.
Modes

VSRP VRID configuration mode

Usage Guidelines

Removing a port is useful because there is no risk of a loop occurring, such as when the port is attached directly to an end host and you plan to use a port in a metro ring.

When a port is removed from VSRP, the port remains in the VLAN but its forwarding state is not controlled by VSRP.

The no form of the command removes the ports from VSRP.

Examples

The following example shows how to remove a port from the VRID. 

device(config)# vlan 200
device(config-vlan-200)# tagged ethernet 1/1/1 to 1/1/8
device(config-vlan-200)# vsrp vrid 1
device(config-vlan-200-vrid-1)# no include-port ethernet 1/1/2
Parent topic: Commands I