`ipv6 dhcp-relay distance`

Assigns the administrative distance to IPv6 DHCP static routes installed in the IPv6 route table for the delegated prefixes on the interface.

Syntax

ipv6 dhcp-relay distance value

no ipv6 dhcp-relay distance value

Command Default

The administrative distance is not assigned.

Parameters

value: Assigns the administrative distance to DHCPv6 static routes on the interface. The range is from 1 through 255. If the value is set to 255, then the delegated prefixes for this interface will not be installed in the IPv6 static route table.

Modes

Interface configuration mode

Usage Guidelines

The no form of the command sets the parameter to a default value of 10.

The administrative distance value must be set so that it does not replace the same IPv6 static route configured by the user.

Examples

The following example sets the administrative distance value to 25.

device(config-if-eth2/1)# ipv6 dhcp-relay distance 25

History

Release version	Command history
08.0.10d	This command was introduced.
08.0.30	Support for this command was added in FastIron 08.0.30 and later releases.

ipv6 dhcp-relay distance