ip pim border
Configures PIM parameters on an interface on a PIM Sparse border.
Command Default
The interface is not configured as a border device.
Modes
Interface configuration mode
Usage Guidelines
The
no form of this command removes the boundary on a PIM-enabled interface.
You can configure this command only in a PIM Sparse domain, that is, you must configure
the
ip pim-sparse command before you configure the
ip pim border command.
Examples
This example adds an IPv4 interface to port 1/2/2, enables PIM Sparse on the interface and configures it as a border device.
Device(config)# interface ethernet 1/2/2 Device(config-if-e10000-1/2/2)# ip address 207.95.7.1 255.255.255.0 Device(config-if-e10000-1/2/2)# ip pim-sparse Device(config-if-e10000-1/2/2)# ip pim border