ipv6-neighbor inspection trust

Enables trust mode for specific ports.
Syntax
ipv6-neighbor inspection trust [ vrf vrf-name ]
no ipv6-neighbor inspection trust [ vrf vrf-name ]
Command Default

Trust mode is not enabled. When you enable ND inspection on a VLAN, by default, all the interfaces and member ports are considered as untrusted.

Parameters
vrf
Specifies the VRF instance.
vrf-name
Specifies the ID of the VRF instance.
Modes

Interface configuration mode

VRF configuration mode

Usage Guidelines

The no form of the command disables trust mode on ports.

Examples

The following example displays the trust mode configuration for ports. 

device(config)# interface ethernet 1/1/3
device(config-if-e1000-1/1/3)# ipv6-neighbor inspection trust

The following example displays the trust mode configuration on a port on VRF 3. 

device(config-if-e1000-1/1/1)# ipv6-neighbor inspection trust vrf 3
History
Release version Command history
08.0.20 This command was introduced.
Parent topic: Commands I