inline power interface-mode-2pair-pse

Corrects a condition where some non-standard powered devices (PD) are undetected on PoH ports due to difference in allowed capacitance between a 2-pair port and a 4-pair port.
Syntax
inline power interface-mode-2pair-pse
no inline power interface-mode-2pair-pse
Modes

Interface port

Usage Guidelines

This command is applicable for 4pair pse ports of all ICX platforms.

The 4pair ports are moved to AT mode when overdrive is disabled using the no inline power overdrive command and port is made 2pair.

Before this command is executed the user may see the following behavior: 

device(config-if-e2500-1/1/36)# show inl pow 1/1/36

Port   Admin   Oper    ---Power(mWatts)---  PD Type  PD Class     Pri  Fault/
        State   State   Consumed  Allocated                             Error
-----------------------------------------------------------------------------
1/1/36 On      Off            0         0   n/a      n/a            3  overload state

Examples

When the Operating State is listed as Off, there is no power consumed or allocated, and the PD is not recognized. The following example will correct this problem: 

device(config-if-e2500-1/1/36)# inline power interface-mode-2pair-pse
device(config-if-e2500-1/1/36)# show inl pow 1/1/36                  

Port   Admin   Oper    ---Power(mWatts)---  PD Type  PD Class     Pri  Fault/
        State   State   Consumed  Allocated                             Error
-----------------------------------------------------------------------------
1/1/36 On      On          8088     28850   2P-IEEE  Class 4        3  n/a

When the operating state is listed as Overload with the default configuration, use this command to provide power. 

device# configure terminal
device(config)# interface ethernet 1/1/1
device(config-if-e1000-1/1/1)#inline power interface-mode-2pair-pse
device(config-if-e1000-1/1/1)#write mem

History
Release version Command history
08.0.30 This command was introduced.
Parent topic: Commands I