inline power adjust class

Use these commands when powered devices (PDs) are entering an overload state as a result of faulty PDs power requests.
Syntax
inline power adjust classr class { delta milliwatts | minimum milliwatts }
no inline power adjust classr class { delta milliwatts | minimum milliwatts }
Parameters
class
The detected PD class for which this configuration is applied to. Values ramge from 0 through 4.
delta
Tthe amount of extra power allocated above the LLDP/CDP requested power.
milliwatts
The additional allocated power measured in milliwatts.
minimum
The minimum power that must be allocated, even if the PD LLDP/CDP requested power is lower than the configuration.
Modes

Global configuration mode

Usage Guidelines

These configurations should be used only when ports are entering an overload condition because of faulty PDs that are requesting lower power through LLDP/CDP messages and then consuming higher than the requested power.

The delta option assures the power allocation is equal to LLDP/CDP requested power plus delta power that is configured for that PD class.

The minimum option assures that the power allocation is equal to the maximum of LLDP/CDP power requested and the minimum power configured for that PD class.

Given a configuration of inline power adjust class 1 delta 800. If a class 1 PD is connected and is requesting power of 2600 milliWatts through LLDP/CDP, then the total allocation from the switch would be 3200 milliWatts. But if a class 2 PD is connected then there won't be any extra power allocation. If you want the extra power allocation for a class 2 PD, the configuration would be inline power adjust class 2 delta 800.

Examples

Set the detected PD class to 1 and allocate 800 milliwatts of extra power for the class. 

device(config)# inline power adjust class 1 delta  800

Set the detected PD class to 1 and allocate minimum power (in milliwatts) regardless of the LLDP/CDP requested power level. 

device(config)# inline power adjust class 1 minimum  3200
History
Release Command History
08.0.30f This command was introduced.
Parent topic: Commands I