inline power install-firmware scp
inline power
install-firmware
{
all
|
stack-unit
unit-id
}
scp
{
ipv4-address-
|
ipv4-hostname-
|
ipv6
{
ipv6-address-
|
ipv6-hostname-
}
outgoing-interface
{
ethernet
stackid/slot/port
|
ve
ve-number
}
}
[
public-key
{
dsa
|
rsa
}
]
[
remote-port
]
remote-filename- stack-unit unit-id
- Specifies the unit ID of the FastIron device in the stack to copy the PoE firmware.
You must specify the stack unit when you configure the
inline power install-firmwarecommand to upgrade PoE firmware on a stacking device. - ipv4-address-
- Specifies the IPV4 address of the SCP server, using 8-bit values in dotted decimal notation.
- ipv6-address-prefix/prefix-length
- Specifies the IPV6 address of the SCP server. You must specify this address in hexadecimal using 16-bit values between colons, as documented in RFC 2373.
- public-key
- Specifies the type of public key authentication to use for the connection, either digital signature algorithm (DSA) or Rivest, Shamir, and Adelman (RSA) . If you do not configure this parameter, the default authentication type is password.
Privileged EXEC mode
You are prompted for username and password when you configure this command.
If you do not configure the type of public key authentication, the default authentication type is password.
In releases prior to 08.0.61, PoE firmware installation could be initiated only on one SPX unit or stack unit at a time.
From 08.0.61 release onwards, PoE firmware installation can also be initiated on all PoE units, or on multiple stack or SPX units simultaneously.
You must specify the stack unit and module when you configure the
inline power install-firmware command to upgrade PoE firmware on a stacking device.
| Release version | Command history |
|---|---|
| 08.0.20 | This command was introduced. |
| 08.0.61 | The command was modified to add the all keyword. |