Performing the Upgrade
RUCKUS strongly recommends backing
up the controller cluster before performing the upgrade. If the system crashes for
any
reason, you can use the latest backup file to restore the controller cluster.
If you have an FTP server, back up the entire cluster and upload the backup files from all the nodes in a cluster to a remote FTP server.
- Copy the software upgrade file that you received from RUCKUS to the computer where you are accessing the controller web interface or to any location on the network that is accessible from the web interface.
- Go to .
- Select the Upgrade tab.
- In Upload, select the Run Pre-Upgrade Validations check box to verify if the data migration was successful. This option allows you to verify data migration errors before performing the upgrade.
- Click Browse to select the patch file.
- Click
Upload to upload the controller configuration to the one in the patch file.
The controller uploads the file to its database, and then performs file verification. After the file is verified, the Patch for Pending Upgrade section is populated with information about the upgrade file. If data migration was unsuccessful, the following error is displayed: Exception occurred during the validation of data migration. Please apply the system configuration backup and contact system administrator.
- Click Backup & Upgrade to perform the upgrade. The backup operation is done before the system upgrade flow starts. The backup file will be used to restore cluster automatically while the upgrade process fails. Refer to Creating a Cluster Backup for more information.
In the Current System Information section, check the value for controller version. If the firmware version is newer than the firmware version that controller was using before you started the upgrade process, then the upgrade process was completed successfully.
Note: APs periodically
send scheduled configuration requests to the controller, including the firmware
version. Therefore, when an AP joins a zone for the first time, the firmware
version is verified by the controller. If the firmware version is different from
that which is configured for the zone, the controller responds with a request
to
upgrade it, after which the AP initiates a request to upgrade the firmware using
HTTP.