IPv6-Only Mode

In the IPv6-Only Mode, all communication operates exclusively over the IPv6 protocol and IPv4 is completely disabled.

Feature Overview

In the IPv6 environment, all the devices and services communicate using IPv6 protocol only. Network architecture is simplified as network avoids dual-mode configurations (IPv4 and IPv6).

Requirements

The following are the requirements for implementing IPv6-Only mode for the controller.

  1. All network devices must support the IPv6 protocol. Devices and servers must have an operating system with IPv6 stack support.
  2. Configure IPv6 address allocation using DHCP.
  3. For environments that still require interaction with IPv4 systems, use NAT and DNS to facilitate communication between IPv6-only clients and IPv4 servers.
  4. Implement security policies specific to IPv6.
  5. Utilize built-in IPsec for secure communications.

Considerations

The following are the key considerations for implementing IPv6-Only mode for the controller.

  1. Verify all devices support IPv6 protocol.
  2. Use well-structured IPv6 addressing plan to avoid overlapping or inefficiencies. Leverage DHCP for dynamic address assignments.
  3. Deploy NAT/DNS for communication with IPv4 environment.
  4. Update firewall rules and access control lists (ACLs).

Best Practices

The following are the best practices for deploying IPv6-Only mode for the controller.

  1. Design an efficient addressing scheme to simplify routing.
  2. Establish an IPv6-Only mode of testing environment before deployment.
  3. Use NAT/DNS transitional mechanisms for clients needing access to IPv4 servers.

Prerequisites

The following are the prerequisites for implementing IPv6-Only mode for the controller.

  1. Verify that all routers, switches, firewalls, and load balancers have native IPv6 support.
  2. Ensure servers, client devices, and operating systems support IPv6 stacks.
  3. Use DNS servers capable of handling IPv6-to-IPv4 translation when required.
  4. Configure DHCP for address auto-assignment.

Limitations

The following are the limitations for implementing IPv6-Only mode for the controller.

  1. A network can be aligned to IPv4 and IPv6 or IPv6-Only mode based on the operational requirements.
  2. IPv6-Only mode can be applied only during the fresh installation.
  3. Switching the IP mode between IPv6-only and dual-stack, or from any other mode to IPv6-only, is not permitted.
  4. In the current setup, restoring configuration from IPv4 or IPv4 and IPv6 mode to IPv6-Only mode is not supported.
  5. The Data Plane is not supported on an IPv6-only node. Consequently, the controller WebUI removes all Data Plane-related options.