Creating a Bond Port Profile

A Bond port profile aggregates multiple network interfaces into a single logical interface. Existing Ethernet configurations must be removed before forming a bonding interface. As both Ethernet links should operate at the same speed, the link speed must be downgraded and should be set to 1 Gbps.
Following default configurations are chosen when the bond is formed on the AP:
Mode: 8023AD
LACP-rate: slow
MII-Mon: 100 (ms)
Xmit-Hash: layer2+3
  1. To create a bond-port profile follow these steps.
  2. From the main menu go to Services > Tunnels & Ports > Bond Port.
  3. Select the zone or AP Group and click Create.
    The Create Bond Profile page is displayed.
  4. Configure the following options:
    1. General Options
      1. Name: Enter a name for the Bond port profile that you are creating.
      2. Description: Enter a short description about the profile.
      3. Type: The Ethernet port type configuration. You can set the Ethernet ports on an AP to one of the following types: Trunk Port, Access Port, or General Port.
    2. VLAN Options
      1. VLAN Untag ID:
      2. VLAN Members:
  5. Click OK.
Parent topic: Link Aggregration Protocol (LACP)