ZoneDirector CLI Setup Wizard

The CLI setup wizard allows you to quickly configure your controller with basic settings using a short series of CLI commands.

ZoneDirector's default IP address is 192.168.0.2, and the default admin login name and password are: admin/admin. You can change these settings from their default values, set the system name and country code, and deploy your first WLAN using the setup wizard.

login as:

Please login: admin
Password:


Welcome to the Ruckus Wireless ZoneDirector CLI Wizard Configuration Tool


Would you like to start setup wizard? [yes/no]: y

Begin wizard from CLI :

...
...
...

Please review the following settings:
System Name=              ZoneDirector
Administrator Name=       admin
Country Code=             US
Mesh Supported=           Enable
IPv4 Supported=           Enable
IPv4 Mode=               DHCP
IPv6 Supported=           Disable
Wireless LANs ESSID=      Ruckus1
Wireless Authentication=  WPA2_PSK


Are you sure to complete the setup wizard: [yes/no]: y

The ZoneDirector will periodically connect to Ruckus Wireless and Ruckus Wireless will collect
the ZoneDirector serial number, software version and build number. Ruckus Wireless will transmit
a file back to the ZoneDirector and this will be used to display the current status of the
ZoneDirector Support Contract. Please be advised that this information may be transferred and
stored outside of your country of residence where data protection standards may be different.


Hi, enter YES to accept these terms to proceed: [yes]:

Save the configuration ...

Welcome to the Ruckus Wireless ZoneDirector 1200 Command Line Interface
ruckus>