Configure System Commands
Use the sys or system command to configure the controller’s system settings, including
its host name, FlexMaster server, NTP server, SNMP, and QoS settings. To run these
commands, you must first enter the
config-sys context.
In this section:
systemdot11-country-codehostname- Interface Commands
- NTP CommandsUse the following commands to configure Network Time Protocol (NTP) server settings.
- Timezone CommandsUse the following commands to configure system time zone settings, including user-defined time zones and Daylight Savings Time (DST) customization.
- FTP CommandsUse the following commands to configure FTP settings.
- Smart Redundancy Commands
- Management Interface Commands
- SNMPv2 Commands
- SNMPv3 Commands
- Syslog Settings Commands
- Management Access Control List Commands
- QoS Commands
tunnel-mtulwapp-mgmt-qlen-thresholdbonjourno bonjourtelnetdno telnetdstatic-routeno static-routestatic-route-ipv6no static-route-ipv6snmp-trapno snmp-trapno snmpv2-trapno snmpv3-trapno snmpv2no snmpv3login-warningno login-warningevent-log-levelsupport-entitleURL-Filtering-License-Renewsession-stats-resvno session-stats-resvarc-data-transmissionno arc-data-transmissionsession-limit-unauth-statsno session-limit-unauth-statseapol-no-retryno eapol-no-retryshared-username-control-enableno shared-username-control-enableshowshow support-entitleshow URL-Filtering-Licenseshow shared-username-control
Parent topic: Configuring Controller Settings