ip

Sets up IP address.
Syntax
ip { control-nat | default-gateway | default-gateway-ipv6 | internal-subnet | ipv6-route | name-server| name-server-ipv6 | route | separate-access-core }
no ip { control-nat | ipv6-route | name-server | route | separate-access-core }
Command Default

No IP address is setup.

Parameters
control-nat
Set Control NAT IP.
default-gateway
Set default gateway.
default-gateway-ipv6
Set IPv6 default gateway.
internal-subnet
Set internal subnet prefix.
ipv6-route
Set IPv6 static routes.
name-server
Set name server.
name-server-ipv6
Set IPv6 name server.
route
Set static routes.
separate-access-core
Enable separate access and core gateway.
Modes

Global configuration mode

Usage Guidelines

The no form of this command removes the user specified ip addresses.

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

Examples

The following example displays setting up ip address.

device(config)# ip
  control-nat              Set Control NAT IP
  default-gateway          Set default gateway
  default-gateway-ipv6     Set IPv6 default gateway
  internal-subnet          Set internal subnet prefix
  ipv6-route               Set IPv6 static routes
  name-server              Set name server
  name-server-ipv6         Set IPv6 name server
  route                    Set static routes
  separate-access-core     Enable separate access and core gateway
Examples

The below example displays no ip .

device(config)#  no ip
  control-nat              Delete Control NAT IP
  ipv6-route               Delete IPv6 static routes
  name-server              Delete all name servers
  route                    Delete static routes
  separate-access-core     Separate access and core gateway
Parent topic: Commands G through I