Commands O through Sh

In this section:

  1. operator-profile
    Creates or updates a WiFi operator profile configuration.
  2. outbound-firewall
    Creates or updates the outbound firewall configuration.
  3. output-format
    Enables output formatting.
  4. patches
    Uploads, applies and displays patch scripts.
  5. ping
    Sends an ICMP echo request to the network host.
  6. ping6
    Sends an ICMP echo request to the network host.
  7. profile-based-nat
    Enables or disables the display of NAT server configuration, when the customer logins the next time.
  8. proxy-aaa
    Creates or updates the proxy AAA server configuration settings.
  9. radius-service
    Configures the RADIUS service options.
  10. rbddump
    Displays the board data of the controller.
  11. rebalance-aps
    Rebalances the AP load across control or dataplane nodes that exist within a cluster.
  12. reboot
    Reboots the controller.
  13. reindex-elasticsearch-all
    Reindexes all elastic search data.
  14. reload
    Reloads the controller immediately or after a specified period of seconds.
  15. reload ap
    Reboots an access point (AP).
  16. reload data-plane
    Reboots a dataplane.
  17. remote ap-cli
    Executes remote access point (AP) CLI commands.
  18. remote-syslogd
    Enables or disables the redirection of syslog to the remote syslog server.
  19. report
    Creates and updates the report configurations.
  20. reset
    Resets the DHCP server binding or profiles and NAT server profile.
  21. restore
    Restores the local cluster or the entire cluster system.
  22. restore
    Restores the controller configuration.
  23. restore config
    Restores a configuration backup file that you uploaded to the FTP server.
  24. restore network
    Restores the network configuration.
  25. rks-gre
    Creates or updates the RUCKUS GRE configuration.
  26. route
    Sets up the route configuration.
  27. save-log
    Saves the debug log to the remote controller.
  28. scan-jmxport
    Scans the JMX port.
  29. sci-profile
    Enables the SCI profile settings.
  30. screen-pagination
    Enables the screen pagination.
  31. service
    Starts, stops, or restarts all the controllers services.
  32. harp://6a7214064c282d8ad6c44b90/pr/ORIGINAL/RUCKUS%20SmartZone%20(ST-GA)%20Command%20Reference%20Guide,%207.0.0_v2_GUID-1FFACC48-E895-46F1-B0C4-6AF88BF30FF6/%20session-timeout_300_100%20=GUID-7AE1F2B0-EBBB-4912-94CD-28DDCD98DA89=2=en-US=.xml
  33. set-factory
    Resets the controller system to factory settings.
  34. setup
    Sets up the controller network interface settings.
  35. sha1
    Enables Secure Hash Algorithm 1 (SHA1) support.
  36. shutdown
    Shuts down the controller immediately, or after a specified period.
  37. ssh-security-level
    Secure Shell (ssh) protocol is a cryptographic network protocol for operating network services.