ap-auto-tagging

Sets up critical access point (AP) auto tagging rules and enters AP auto tagging configuration mode.
Syntax
ap-auto-tagging
no ap-auto-tagging enable

After the ap-auto-tagging command is entered to enable the AP auto tagging configuration mode, the following configuration syntax is available:

[ enable ]

After the enable command is entered in AP auto tagging configuration mode, the following configuration syntax is available:

[ rule daily-threshold | threshold value | unit { g | m } ]
Command Default

Auto tagging rules for APs is not set up.

Parameters
no ap-auto-taggingenable
Disables critical AP auto tagging.
enable
Enables the auto-tagging of critical APs.
ruledaily-threshold
Sets the auto tagging rule to daily traffic bytes, which exceeds the threshold rule.
thresholdvalue
Sets the threshold value.
unit
Sets the unit.
g
Sets the unit to gigabytes.
m
Sets the unit to megabytes.
Modes

Global configuration mode

Usage Guidelines

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

The no form of the command disables critical AP auto tagging.

Examples

The following example enables auto tagging for APs and enters AP auto tagging configuration mode. It also sets the auto tagging rule to daily traffic bytes. 

device# config
device(config)# ap-auto-tagging
device(config-ap-auto-tagging)# enable
device(config-ap-auto-tagging)# rule daily-threshold

The following example disables auto tagging for APs. 

device# config
device(config)# no ap-auto-tagging enable
Parent topic: Commands A through C