diag
Enables the running of diagnostic
commands.
Syntax
diag
{
cfgfwd
|
cfgwlan
|
cfg3rdwlan
|
dp_comm
|
dp_cia_client|
ps
|
tbldump
|
top
|
tunnelmgr_cli
|
tunnelmgr_client_cli
}
Command Default
Diagnostic commands are not run.
Parameters
Modes
Debug configuration mode
Usage Guidelines
This command is supported on the SmartZone Data Plane controllers only.
Examples
The following example displays the tunnel manager set of commands.
device> debug
device(debug)# diag tunnelmgr_cli
Usage: tunnelmgr_cli [-d -D] {-a | -c | {-g all|<tun_id>|global|cb} | {-s cert_check <enable/disable>} | {-t <secs>} | {-r <secs>} | {-v <enable/disable>}}
-a -- Add a tunnel table entry
-c -- Clear all tunnel table information
-g all|global|cb|<tun_id> -- Get information for all valid entries,
for specified tunnel entry, or for global data,
for tunnelmgr cb
-s cert_check <enable/disable> > -- Set , certificate velidation on/off
-t <secs> -- Set garbage collection timeout interval (seconds)
-k <secs> -- Set cleanup interval based on heartbeat interval (seconds)
-l <0~7> -- Set log level of tunnelmgr
-r <secs> -- Calculate average RX/TX bit/pkt rates within the seconds you sepcify
-v <enable/disable> -- Enable/Disable certificate vilidation
-v -- verbose, show more information
-V -- Very verbose, show all detailed information