Desktop installation
Complete the following steps to install the ICX 7250 device on a desktop or other flat surface. The device you are installing might look different than the one in the following illustration.
Danger: This equipment is suitable for mounting on concrete or other noncombustible surfaces
only.
- Attach the four adhesive feet to the bottom of the device. If installing multiple devices, attach the adhesive feet to each device.
- Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that adequate ventilation is provided for the system. A 7.62 cm (3 in.) clearance is recommended on each side.
- If installing a single device only, proceed to Powering on the system. If installing multiple devices, place each device squarely on top of the one below.