Configuring Model-Based Settings

You can apply a set of settings to all APs of a particular model, use the Model Specific Options section.

Complete the following steps to configure model based settings.

  1. Click Network > Wireless > Access Points.
  2. From the list, select AP for which you want to apply model-based settings and click Configure. This displays Edit AP.
  3. Scroll down to Model Specific Options section, expand the section.
  4. In Model Specific Control, select Override zone config checkbox. The settings available for the AP model are displayed.
  5. In the General Options section, configure the following settings.
    Note: The options that appear in the Model Specific Options section depend on the AP model that you select. Not all the options described in the following table are displayed for every AP model.
    Note: For H series AP models such as H500 and H510, you can disable LAN5.
  6. In the Port Settings section, configure the following options for each LAN port.
    Note: The number of LAN ports that appear in this section correspond to the physical LAN ports that exist on the selected AP model.
    Note: When trunk port limitation is enabled, the controller does not validate the port settings configured in the AP or the AP group with no members.
  7. Click OK.

Parent topic: AP Model Specific Configuration