Status Mode Selection Button and STATUS LEDs

You must press the STATUS mode selection button to display the corresponding status indicated by the port status LED. Each press of the STATUS mode selection button selects the next mode in the following sequence:

  1. STAT: Port link status mode (default)
  2. SPD: Port speed status mode
  3. ID: Member ID status mode
  4. USB: USB status mode
  5. PoE: PoE status mode (applies only to the P and ZP models)
Note: When in USB mode, pressing the status mode selection button for more than five seconds copies files, such as image and manifest files, configuration files, and Show Tech (supportsave) files from the device to the USB drive.

In this section:

  1. Port Link Status Mode (STAT) LED
    The port link status mode (STAT) LED displays the link status and activities of each port. Each unit within the stack will also display the local port status.
  2. Port Speed Status Mode (SPD) LED
    Port speed status mode (SPD) displays the speed setting of each downlink and uplink port (including modules).
  3. Member ID Status Mode (ID) LED
    The member ID status mode (ID) LED displays the Stack ID.
  4. Status Mode (USB) LED
    Refer to the following tables to interpret the status mode (USB) LED.
  5. Status Mode (PoE) LED (N/A for Non-PoE)
    Status mode (PoE) displays the PoE status of each downlink port. Refer to the following table to interpret the Power over Ethernet (PoE) status LED.
Parent topic: Interpreting Port-Side LEDs