snSFlowGlb

Note: ICX 8100 devices support sFlow sampling rate configuration only at the global level. They do not support the sflow sample or sflow enable commands at the interface level. However, the sflow forwarding command is supported only at the interface level.

Name, OID and Syntax

Access

 Description
snSFlowGlb

1.3.6.1.4.1.1991.1.1.3.19.1

Syntax: EnabledStatus

Read-only

Enable sFlow sampling globally to enable or disable sFlow sampling on all interfaces.

Disabled: sFlow sampling disabled.

Enabled: sFlow sampling enabled.

The default value is Disabled.

snSflowStatus

1.3.6.1.4.1.1991.1.1.3.19.1.1

Syntax: EnabledStatus

 Read-only

To enable or disable sflow sampling on all the interfaces.

disabled - sflow sampling disabled

enabled - sflow sampling enabled

Unless globally enabled, it cannot be enabled on an interface specifically.

The default value is disabled.

snSflowSampleRate

1.3.6.1.4.1.1991.1.1.3.19.1.2

Syntax: Unsigned32

 Read-only To set the rate at which the packet sampling occurs. For example, a value of 512 means every 512th packet is sampled for sflow collection.

The default value is 4096.
snSflowSourcePort

1.3.6.1.4.1.1991.1.1.3.19.1.3

Syntax: Unsigned32

 Read-only To set the UDP source port for sending the sflow samples to the configured collectors. Any permissible value can be configured for this and default value is 8888.
snSflowAgentAddrType

1.3.6.1.4.1.1991.1.1.3.19.1.4

Syntax: InetAddressType

 Read-only To set the Agent IPv4/IPv6 address type on the switch. Sflow uses the Agent IP address in the samples sent to collector and this address is dynamically determined based on L2/L3 switch, but can be administratively set also.
snSflowAgentAddr

1.3.6.1.4.1.1991.1.1.3.19.1.5

Syntax: InetAddress

 Read-only To set the Agent IPv4/IPv6 address on the switch. sFlow uses the Agent IP address in the samples sent to collector and this address is dynamically determined based on L2/L3 switch, but can be administratively set also.
Parent topic: sFlow