Web Authentication Auth-Filter Configuration

The following table applies to Web authentication at the VLAN or port level only.

Name, OID, and syntax

Access

Description

ruckusWebAuthFilterTable

snSwitch.44.1.4.5

Syntax: SEQUENCE OF RuckusWebAuthFilterEntry

 None

A table that allows configuration of Web authentication auth-filters, which are applied to statically authenticate the clients without the need for authentication. This helps to permit or deny predefined clients and save time in authentication. An entry exists in this table for every auth-filter defined on this VLAN.
ruckusWebAuthFilterEntry

snSwitch.44.1.4.5.1

Syntax: RuckusWebAuthFilterEntry

 None An entry in Web authentication auth-filter table.
ruckusWebAuthFilterMac

snSwitch.44.1.4.5.1.1

Syntax: MacAddress

 None Specifies the MAC address of the filter for matching the authenticating clients through static authentication.
ruckusWebAuthFilterPort

snSwitch.44.1.4.5.1.2

Syntax: InterfaceIndexOrZero

 Read-only

Specifies the port in the VLAN, where this filter should be applied. If the port is not valid, the entry applies to all ports in that VLAN.
ruckusWebAuthFilterDuration

snSwitch.44.1.4.5.1.3

Syntax: Unsigned32 (0..128000)

 Read-only

Specifies the time for blocking or allowing the user when the filter results in authenticating the user matches.

The value of "0" means the user is blocked permanently or allowed permanently. The unit is measured in seconds.
ruckusWebAuthFilterAction

snSwitch.44.1.4.5.1.4

Syntax: INTEGER

{ permit(1),

deny(2) }

 Read-only

Specifies the action to be performed when this filter is applied on the authenticating client when matching occurs.

  • permit(1): Allows the client in the specified VLAN
  • deny(2): Blocks the client
Parent topic: Flexible Authentication MIB