show

To display the WLAN settings, use the following command:

show

Syntax Description

show
Display WLAN settings

Defaults

None.

Example

ruckus(config)# wlan ruckus1
The WLAN service 'ruckus1' has been loaded. To save the WLAN service, type 'end' or 'exit'.
ruckus(config-wlan)# show
WLAN Service:
  ID:
    1:
      NAME = Ruckus-Wireless-1
      Tx. Rate of Management Frame(2.4GHz) = 2.0Mbps
      Tx. Rate of Management Frame(5GHz)   = 6.0Mbps
      Beacon Interval = 100ms
      SSID = Ruckus-Wireless-1
      Description = Ruckus-Wireless-1
      Type = Standard Usage
      Authentication = open
      Encryption = wpa
      Algorithm = aes
      Passphrase = password
      FT Roaming = Disabled
      802.11k Neighbor report = Disabled
      Web Authentication = Disabled
      Authentication Server = Disabled
      Accounting Server = Disabled
      Called-Station-Id type = wlan-bssid
      Tunnel Mode = Disabled
      DHCP relay = Disabled
      Max. Clients = 100
      Isolation per AP = Disabled
      Isolation across AP = Disabled
      Zero-IT Activation = Enabled
      Load Balancing = Disabled
      Band Balancing = Disabled
      Wifi6 = Enabled
      Service = Enabled
      Dynamic PSK = Enabled
      Dynamic PSK Passphrase Length =
      Limit Dynamic PSK = Disabled
      Auto-Proxy configuration:
        Status = Disabled
      Inactivity Timeout:
          Status = Disabled
      VLAN-ID = 1
      Dynamic VLAN = Disabled
      Closed System = Disabled
      OFDM-Only State = Disabled
      Multicast Filter State = Disabled
      802.11d State = Disabled
      Force DHCP State = Disabled
      Force DHCP Timeout = 0
      DHCP Option82:
          Status = Disabled
          Option82 sub-Option1 = Disabled
          Option82 sub-Option2 = Disabled
          Option82 sub-Option150 = Disabled
          Option82 sub-Option151 = Disabled
      Ignore unauthorized client statistic = Disabled
      STA Info Extraction State = Enabled
      BSS Minrate = Disabled
      Call Admission Control State = Disabled
      PMK Cache Timeout= 720 minutes
      PMK Cache for Reconnect= Enabled
      NAS-ID Type= wlan-bssid
      Roaming Acct-Interim-Update= Disabled
      PAP Message Authenticator = Enabled
      Send EAP-Failure = Disabled
      L2/MAC = No ACLS
      L3/L4/IP Address = No ACLS
      L3/L4/IPv6 Address = No ACLS
      Precedence = No ACLS
      Proxy ARP = Disabled
      Device Policy = No ACLS
      Role based Access Control Policy = Disabled
      SmartRoam = Disabled  Roam-factor = 1
      Allow List = No ACLS
      Application Visibility = disabled
      Apply Policy Group = No_Denys


ruckus(config)#