show zone

Displays information about AP zone states.
Syntax
show zone[zone-name{ap[ap-mac-address]|client[client-mac-address]|wired-client[wired-client-mac-address]}]
Parameters
zone-name
Zone name
apap-mac-address
Displays information for the specified AP zone or all AP zones.
clientclient-mac-address
Displays information for the specified client list of a specific AP zone.
wired-clientwired-client-mac-address
Displays information for the specified wired client list of a specific AP zone.
Modes

Privileged EXEC mode

Usage Guidelines

The show zone command without any options displays information about all AP zones.

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

Examples

The following example displays the output for the show zone command without any options. 

device# show zone 
 No.   Zone Name           Management Domain        Description         AP Firmware  # of Alarms         # of APs       # of WLANs  # of Clients  AP IP Mode
   ----- ------------------- ------------------------ ------------------- ------------ ------------------- -------------- ----------- ------------- -----------
   1     3.6_ZONE            Administration Domain                        6.0.0.99.11  0/0/0/0             0 (0/0/0/0/0)  7           0             Dual
                                                                          85
   2     Staging Zone        Administration Domain    Staging Zone                     0/1/0/0             1 (0/1/0/0/0)  0           0
   3     6.1315-Wired-ZONE   Administration Domain    6.1315-Wired-ZONE   6.0.0.99.12  0/0/0/0             1 (1/0/0/0/0)  0           0             IPv4
                                                                          59
   4     6.1213-GP-AP-ZONE   Administration Domain    6.1213-GP-AP-ZONE   6.0.0.99.12  0/0/0/0             0 (0/0/0/0/0)  1           0             IPv4
                                                                          59
   5     GA_ZONE             Administration Domain                        6.0.0.0.158  0/0/0/0             0 (0/0/0/0/0)  1           0             Dual
                                                                          1

The following example displays the output for the show zone command for the GA Zone. 

device# show zone GA_ZONE
ap             client         wired-client
Parent topic: Show Commands